PRL-175A, Battery Operated TTL Logic Level Generator and 10 MHz Clock Source

Mini Modular Instruments > Clock Sources > PRL-175A

Applications:

• Pocket-sized Signal Source Outputs Valid TTL Hi/Lo or Squarewave Signal
• Low Jitter TTL Xtal Clock Source
• Amplifier Response Testing
• Triggering or toggling TTL device
• TDR Testing, with PRL-812TDR Splitter
• Ideal Field Trouble Shooting Tool
• General Purpose Basic Lab Tool

Features:

• 0 V/5 V DC or 10 MHz TTL Square Wave into Hi Z or 2.5 V into 50 Ω.
• 25 ppm Xtal stability
• 50 Ω Output drives long lines with or without 50 Ω load termination
• t_R/t_F < 2 ns typical into 50 Ω
• Frequency jitter < 20 ps
• BNC Output Connector
• 9V Battery pack with On/Off switch included
• 10 Hr. typical battery life with continuous operation at 10 MHz/50 Ω load (longer at reduced duty cycle)
• Double the operating time with an optional 4-AA battery pack
• Optional 9 V AC Adapter available
• Other Xtal frequencies available on special order
• General Purpose Basic Lab Tool
• 1.0H x 1.3W x 2.2L-in. pocket-size module mounted on a 0.83H x 1.32W x 2.7L-in. battery pack (shown in photo)

Description

The PRL‑175A‑10 is a battery operated, pocket-sized lab tool and troubleshooting aid. It outputs a 0 V/5V DC or 10 MHz Xtal controlled square wave signal into a Hi Z load, or 2.5V into 50 Ω. These are the essential signals for troubleshooting TTL circuits, equipment, and systems. The PRL‑175A‑10 has a 50 Ω back-terminated output driver that can drive a 100 ft long line with or without load termination. It is an indispensible tool for engineers and technicians working in the field, in the lab or on the production floor.

The included 9 V battery pack can power the PRL‑175A‑10 in square wave mode into a 50 Ω load continuously for up to 10 hours, or for 25 hours into a 600 Ω load*. An optional 4‑AA battery pack or a +9V AC adapter is also available.

The output logic mode, V_OH, V_OL or 10 MHz square wave, is selected by a 3-position toggle switch, and the status is indicated by an LED. The PRL‑175A‑10 module can be attached to the battery pack using a short strip of 3M Dual-Lock Fastener (included) and powered via a short cable terminated into a 2.1 mm DC jack. The battery pack also includes an On/Off switch, as shown in the photo above. The assembled unit fits easily into a pocket.

Applications of the PRL‑175A‑10 include precision, low-jitter clock source for testing digital systems, ADCs and amplifiers, and for simple troubleshooting applications. The PRL‑175A‑10 is housed in a 1 x 1.3 x 2.2-in. extruded aluminum enclosure and includes a 0.83H x 1.3W x 2.7L-in. battery pack.

* Run times are typical, and will vary depending on usage profile and environmental conditions.

Related MMI's:

• PRL-414B, 1:4 TTL Fanout Buffer
• PRL-420ND TTL to NECL Translator
• PRL-426T TTL to LVDS Translator
• PRL-420RS TTL to RS422 Translator

PRL-175A | Detail | Diagram | Specifications | Datasheet