Mounting Brackets

Build-Your-Own > Accessories > Mounting Brackets

35001420

• Mount most PRL Basic Lab Tools or Custom Circuit Kits.

 Features:

• Each pair mounts two modules (one pair required)
• Supports most PRL products

Any supported module can be mounted on a flat surface using a pair of the 35001420 mounting brackets.  In fact, one pair of brackets can accommodate any two modules of the same length, as shown in the photo above.

For 2.9" x 1.3" modules, one pair of brackets can accommodate one unit mounted on the 2.9-in. side or two units on the 1.3-in. side as shown in the drawing below.

For the 1.3" x 1.0" modules, the unit can only be mounted on the 1.3-in. side.

See below for a list of all supported modules and sizes.

To mount a module, loosen the two bottom screws from the front and rear end plates in the module and then inserting the module into the forks in the two brackets.  Tighten the screws to the end plates to hold the module in place. 

Click on the diagram below to view a larger version or view PDF.

Supported modules:

• 2.9" x 1.3" modules

  • All PRL Basic Lab Tools Modules except the 1.3" models listed below

  • All PRL-970 Custom Circuit Kits

  • PRL Voltage Distribution Modules

• 1.3" x 1.0" modules

  • PRL-81x series Power Divider/Splitter modules

  • PRL-95000 series coupling capacitors

  • PRL-860 series GHz signal extractors

  • All PRL-950 Custom Circuit Kits

PRL-980 Custom Circuit Kits are not supported.

Price:  $8.00/ea. 

Each configuration shown above requires one pair.

***All prices are for domestic orders only. For international orders, please add 15%. Prices are subject to change without notice. Please consult factory for additional information at 310-515-5330.***

Adapters | Cables | Voltage Distribution | Extrusions | DC Block | Probes | Wrenches